How do I unload/stop rendering tiles that are not seen by the camera?

[Kurt-Dekker]

@gooby429

The camera automatically culls tiles you cannot see

I actually wonder about that now that you mention it… I would assume it would cull but then that would imply that the emergent mesh generated from the Tilemap gets redone regularly, or that it may be pre-sliced into spatially separate chunks. In reality, it might be quite static and quite naively generated.

OP, you could perhaps programmatically chop up your Tilemap at runtime into smaller Tilemaps (when the level loads) and then delete your original Tilemap.

But first make sure that this is really your problem or you will have done a ton of work for nothing.

DO NOT OPTIMIZE “JUST BECAUSE…” If you don’t have a problem, DO NOT OPTIMIZE!

If you DO have a problem, there is only ONE way to find out. Always start by using the profiler:

Window → Analysis → Profiler

Failure to use the profiler first means you’re just guessing, making a mess of your code for no good reason.

Not only that but performance on platform A will likely be completely different than platform B. Test on the platform(s) that you care about, and test to the extent that it is worth your effort, and no more.

Is it still worth optimizing square roots in 2021+?

It depends on the target architecture and runtime library of course, as all computer code runs on the actual CPU where your game is running, not some “theoretical magical global CPU of today” construct. But in 2021 a floating point unit (FPU) is pretty standard on most targets. All that said, don’t do needless work, especially on mobile, as that just burns down battery life. If you suspect you have a performance bottleneck, DO NOT START MAKING OPTIMIZATION CHANGES!! Instead, start with the …

Remember that optimized code is ALWAYS harder to work with and more brittle, making subsequent feature development difficult or impossible, or incurring massive technical debt on future development.

Notes on optimizing UnityEngine.UI setups:

How to efficiently copy transform data into an array

Just so you know, the entire UnityEngine.UI system is available in source control from the package manager (and from github) and you can look at it and probably see there isn’t going to be a lot of fat. If there are some particular specific widgets you use in there that are too slow because of the use-generalization assumptions made, you might be able to get some benefit by tweaking them, but since so much of mobile performance bumps against pixel fill bounds, it’s unlikely to get you much ben…

At a minimum you want to clearly understand what performance issues you are having:

• running too slowly?
• loading too slowly?
• using too much runtime memory?
• final bundle too large?
• too much network traffic?
• something else?

If you are unable to engage the profiler, then your next solution is gross guessing changes, such as “reimport all textures as 32x32 tiny textures” or “replace some complex 3D objects with cubes/capsules” to try and figure out what is bogging you down.

Each experiment you do may give you intel about what is causing the performance issue that you identified. More importantly let you eliminate candidates for optimization. For instance if you swap out your biggest textures with 32x32 stamps and you STILL have a problem, you may be able to eliminate textures as an issue and move onto something else.

This sort of speculative optimization assumes you’re properly using source control so it takes one click to revert to the way your project was before if there is no improvement, while carefully making notes about what you have tried and more importantly what results it has had.