Just upgraded from 2(something) to 3.12
Feels good so far!
In 2 I was able to set different offsets etc per Rig (top,middle,bottom).
Is there a way of accessing these settings per rig in 3? (noticed they are now called rings)
All I can see is the standard height/radius
thanks in advance!
Yes, use the FreeLookModifier behaviour. CM provides one by default (it may be disabled - enable it if that’s the case). If you don’t have it, add one.
It allows you to have settings overrides for the top and bottom rigs (the main inspector holds values for the middle rig, which will be used for top and bottom also unless overrides are specified).
